Draw-tite 75712 MAX-FRAME RECEIVER Manuel d'utilisateur télécharger pdf

Installation Instructions

Jeep Compass*, inc. Rallye Package

Jeep Patriot*, inc. optional tow hook

Part Numbers:

75712

87606

44661

75224

HAUL

2007-2010 Patriot bumper

fascia

Optional tow

hook

*2011 and Later Jeep Patriot and Compass

models require fascia trimming for hitch

installation. Obtain vehicle owner approval

75224

HAUL

Hitch Shown In Proper Position

Equipment Required:

Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating or

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

Do NOT Use With Spring Bars

Weight Carrying

Ball Mount

3500 (1 589 Kg) 525 (238 Kg)

hook

Rallye Bumper

fascia

installation. Obtain vehicle owner approval

before cutting.

2011 & Later Patriot and

Compass fascia To be trimmed.

Equipment Required:

Wrenches: 22mm, 16mm-tow hook option

Drill Bits: 5/8”- Only needed to reinstall

tow hook on Patriot with optional tow hook.

Fastener Kit: 75712F

Wiring Access Location: SUV1, SUV2

Vehicle frame

Rail

Vehicle frame

Cutting Tool: Needed to trim

bumper fascia on Compass Rallye and

2011 & later Patriot and Compass.

Vehicle frame

bushing typical

2011 & later Patriot and Compass.

Note 1.

Patriot with optional tow hook

On Jeep Patriot with optional tow

Optional tow hook

Reattach existing 10mm

bolt to bumper

On Jeep Patriot with optional tow

hook on Driver’s side it is

necessary to remove tow hook.

Check with vehicle owner

to see if they want tow hook

reinstalled. To reinstall hook it is

necessary to press/drive existing

knurled neck bolts out of hook

and drill out with 5/8” drill.

Reinstall hook by using supplied

Figure 1

Qty. (4) M14 x 120 x 2 Hex Bolt Qty. (2) 5/8” Conical Washer

Qty. (2) 5/8” Lock Washer Qty. (4) M14 x 2.0 hex Nut

bolt to bumper

Reinstall hook by using supplied

M14 bolts following steps below.

1. If vehicle has optional tow hook see Note 1. above. For Compass Rallye see Note 2 and Figure 2. Check with vehicle owner. For 2011

and later Jeep Patriot and Compass models. Fascia trimming is required for hitch installation. Obtain vehicle owners approval before

cutting. See

Figure 3 and figure 4

for fascia trimming diagrams.

Tighten all M14

2 fasteners with torque wrench to 100 Lb.

Ft. (136 N*M)

cutting. See

Figure 3 and figure 4

for fascia trimming diagrams.

** 2011 model has 2” vertical fascia trim (measured from the bottom of the fascia lip). Mark fascia with non-permanent marker. Re-confirm fascia cut

height by using figure 4 procedure and mark height from ground on fascia. Cut the lower of the two marks.

1. Place M14 hex bolts into vehicle bushings from the outboard side of the vehicle frame rails. Leave bolt ends flush with the inboard side of

frame rails.

2. Raise hitch into position and push M14hex bolts through hitch frame brackets to support the hitch.

3. Attach remaining hardware as shown above.

4. On Compass Rallye Package only. Use hitch receiver tube as a guide to cut a 2-1/4” wide by 2” high piece out of bumper fascia to allow

clearance for ball mounts. See Figure 2.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Form: F205 Rev A 5-6-05

Tighten all M14

2 fasteners with torque wrench to 100 Lb.

Ft. (136 N*M)

1 2 3 4 5 6

Résumé du contenu

Page 1 - Installation Instructions

Installation InstructionsJeep Compass*, inc. Rallye Package Jeep Patriot*, inc. optional tow hookPart Numbers:75712 87606 44661 752

Page 2

Installation InstructionsJeep Compass*, inc. Rallye Package Jeep Patriot*, inc. optional tow hookPart Numbers:*2011 and Later Jeep Patriot and Compass

Page 3 - Instructions d’installation

Instructions d’installationCrochet de remorquage en option - Jeep Compass*, inc. Rallye Package Jeep Patriot*, inc.Numéros de pièces :Carénage de pare

Page 4

Instructions d’installationCrochet de remorquage en option - Jeep Compass*, inc. Rallye Package Jeep Patriot*, inc.Numéros de pièces :*Les modèles Jee

Page 5 - Instrucciones de instalación

Instrucciones de instalaciónJeep Compass*, inc. paquete Rallye Jeep Patriot*, inc. gancho de remolque opcional Números de partes:Placa protectora del

Page 6

Instrucciones de instalaciónJeep Compass*, inc. paquete Rallye Jeep Patriot*, inc. gancho de remolque opcionalNúmeros de partes:*Los modelos 2011 y po

Commentaires sur ces manuels

Pas de commentaire

Draw-tite 75712 MAX-FRAME RECEIVER Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Draw-tite 75712 MAX-FRAME RECEIVER. Draw-Tite 75712 MAX-FRAME RECEIVER User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Draw-tite 75712 MAX-FRAME RECEIVER