Draw-tite 75896 MAX-FRAME RECEIVER Manuel d'utilisateur télécharger pdf

Installation Instructions

Toyota Highlander

Part Numbers:

75896

87660

44710

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 10mm, 17mm, 19mm, small

screwdriver, Phillips head screwdriver, &

6” socket extension

Frame rail

Sheet 1 of 3 75896N 3/12/14 Rev. A

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 75896F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

8000 (3632 Kg) 900 (409 Kg)

Weight Carrying

Ball Mount

6000 (2724 Kg) 900 (409 Kg)

Wiring Access Location: SUV3, 4

Form: F205 Rev A 5-6-05

Tighten all M12 x 1.25 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)

Tighten all M8 x 1.25 CL8.8 fasteners to 20 Lb.-Ft. (27 N*M)

Qty. (6) Hex Bolt – M12 x 1.25 x 30mm CL8.8

Qty. (6) Conical Toothed Washer – 1/2”

Qty. (2) Washer Conical 3/8

Qty. (2) Nut, M8 x 1.25

Qty. (2) Bolt M8 x 1.25 x 30 CL8.8

Qty. (1) Exhaust Bracket

1. If present, remove plastic appearance panels which cover driver’s and/or passenger’s side frame rails. Remove the plastic

rivets that fasten the fascia tabs to the appearance panel. Note: Remove the center of the rivet with a small screwdriver.

Passenger’s side panel can be reinstalled. Return drivers’ side panel and fasteners to owner.

2. Remove tow hooks from each frame rail and return hooks and fasteners to vehicle owner.

3. Remove plastic and rubber plugs from bottom of frame rail. Return to owner.

4. Remove existing M8 bolts from exhaust hanger bracket. Install exhaust bracket (item 6) on frame rail using existing M8 bolts.

Use M8-1.25 bolts to install exhaust hanger bracket to exhaust bracket.

5. Be careful not to pinch hoses on the outside of the passenger side frame rail or scratch fascia. Remove excess caulking from

rails if needed.

6. Align hitch into position over existing weldnuts as shown and install fasteners to bottom of frame rails.

Note: Existing fascia tab should be reinstalled between frame rail and bracket.

7. Torque all fasteners to specifications.

8. Reinstall passenger side appearance panel.

Frame rail

Fascia

Vehicles

heating/cooling

hoses located in

this area.

Use caution not to

pinch.

Note: When stowing the spare

or flat tire, it may be necessary

to lift up on the rear edge of

the tire to clear hitch.

Existing weldnuts in

both vehicle frame

Accessory Rating

Existing fascia tab

Reuse Existing M8

Bolts

Exhaust hanger

bracket

1 2 3

Résumé du contenu

Page 1 - Installation Instructions

Installation Instructions Toyota Highlander Part Numbers: 75896 87660 44710 Hitch Shown In Proper Position Equipment Required: Wrenche

Page 2 - Instructions d’installation

Onglet existant Instructions d’installation Toyota Highlander Numéros de pièce : Attelage montré dans la position appropriée Équipement requis : Clés

Page 3 - Instrucciones de instalación

Pestaña fascia existente Instrucciones de instalación Toyota Highlander Números de partes: El enganche se muestra en la posición correcta Equipo neces

Commentaires sur ces manuels

Pas de commentaire

Draw-tite 75896 MAX-FRAME RECEIVER Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Draw-tite 75896 MAX-FRAME RECEIVER. Draw-Tite 75896 MAX-FRAME RECEIVER User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Draw-tite 75896 MAX-FRAME RECEIVER