Draw-tite 59401 BIKE CARRIER - TX W_TILT & SECURITY - HI Manuel d'utilisateur télécharger pdf

Product Code:

Product Name:

www.rolaproducts.com

Cequent Towing Products - Plymouth, MI

Technical Service: (888) 521-0510

PRINTED IN CHINA

59401N Rev E 11-23-09

59401

ASSEMBLY INSTRUCTIONS

1. Use key to unlock lock on Collar Bracket.

2. Pull spring loaded release pin on side of Main Support tube, remove handle mechanism, and rotate bike

Support Arms into the UP position. Re-insert the handle mechanism. Pull out the spring loaded release

pin and push handle all the way down. Let the spring loaded pin go so that it fully engages the handle

mechanism.

3. Slide the Collar Bracket onto the bike carrier Main Support tube in orientation shown (see Diagram 1).

4. Attach Collar Bracket to Main Support tube using one (1) ½” x 3-1/4” lg. hex bolt, two (2) nylon flat

washers, and locknut installed through the “slotted” hole in Collar Bracket. Tighten locknut until it is snug

against the flat washers.

5. Attach Receiver piece to Collar Bracket using two (2) ½” x 3” hex bolts through the

½” diameter holes (closest to end of tube). (See Diagram 2)

Tighten Receiver piece bolts to 75 Lb.-Ft.

7. Lock Collar Bracket to Main Support tube so bike carrier is in the upright position.

1/2” x 3-1/4” Hex Bolt

Please read all instructions carefully before assembly, installation and/or use of this product.

2” Shank

½” Locknut

Diagram 1

Diagram 2

Diagram 3

Handle Mechanism

Release

4 Place Bike Carrier - Folding

1/2” x 3-1/4” Hex Bolt

½” Locknut

Nylon Washer

1 2 3 4 5 6 7 8 9